LN, I cant say for sure butttttttt I think what you were told is because they dont want the risk of any cheap inferior wires that may allow a HV arc discharge. I dont think its so much whether they are carbon core suppressor plug wires which reduce radio interefernce or plain old wire core as its the quality HV insulation they are concerend with. Often when people switch to an elec switch thay also use a HV high energy coil and run a wider plug gap which means they are operating at higher then stock firing voltages and worn or inferior plug wires may allow arcing. I think in some instances (more race cars prob not so much a tractor issue) where you use their high performance switches and super high energy HV coils and run wide plug gaps they actually want some impedance in the HV secondary and use spiral wound plug wires???
If you use a set they recommend and supply their warranty ought to be better Id think but just dont use any worn ratty aged wires n you will likely be okay
To get the most bang for the buck that elec switch has to offer I recommend a high energy HV coil (as specified by them to match their coil) and a somewhat wider plug gap with quality insulation wires. Just the elec switch with the stock coil, however, still gives improvement due to faster more positive (no points bounce and ringing) coil current switching.
CONSULT WITH PERTRONIX AND DO AS THEY SAY NOTTTTTTTTTT MEEEEEEEEEE
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
