So, which hydraulic system do you have on your 986, open or closed. Later has flow control valves, open does not unless it has the conversion from closed pfc to a gear type pump. Lot of options here. If original open center type , make sure hitch position control lever is not fully forward into action control range as this dumps fluid. Raise hitch a ways and have load control in heavy positon. Both systems are about 12 gpm and should operate a loader at a reasonable speed unless you have a very large cyl. You could put in a 17 gpm pump but I would sure have own pump flow rate tested before I did that. Also, lever should stay latched when lifting loader, if it does not you have a restriction such as coupler or maybe an orfice in line. Far as adding another valve system, well, original open center hyd system uses a supercharge line from rear pump to front pump so you have to plumb properly to assure that flow. If closed center system, you will need signal lines back to pump from extra valve. Some things to think about.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.