Posted by Bill in IL on September 23, 2009 at 19:59:34 from (98.108.64.176):
THink I finally got it running right after new rings and a head job. In the end it bit me in the butt by trying to not take the manifold off the head (FIL's advice who is right most of the time) I had a leak there and distributor trouble.
I never really checked the timing marks when I had it apart but in the end I found out the hard way its timed to the mark on the right side of the engine. Or lack of mark. On the left there is a sharp point sticking out and on the right a land where they could have put it. Did they switch timing marks some year during production or could I have a different crank pulley thus the wrong mark?
Timing jumps a few degrees at idle but really not worried about that now. Maybe some day I will get brave and spray weld the distributor shaft
Now for the real question.... The clutch is marginal. As in it has a long pressure point till it finally grabs. It starts to grab within about the first inch of letting it up and doesn't grab hard till about the last 1.5 inch of travel. Thinking I got a weak pressure plate. What do you all think?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
