I will be very specific ad see what happens. Find a piece of pipe that is just big enough to let the cap fit inside it. Fill the tank with H2O to the very top of the neck. Put a piece of plastic film on the tank opening and place the cap on and tighten. Place the pipe in a vice or other holder so the tank can be inverted into the pipe (tank up, cap and bent tube down)and is not going to tip or move the pipe (strong sturdy fixture for the pipe). Tape up the neck of the tank with duct tape (torn into a 1/2" width) at the top just under the cap, and at the tank, making it just fit into the pipe. Turn the tank upside down into the pipe. Open the tank valve, and put no more than 15 PSI in it with an air hose into the valve (fittings and a screw in schrader valve from a tire repair store would help. As the pressure is applied, pull on the tank to straighten the neck. This will apply bothe mechanical and hydraulic pressure (a couple of hundred pounds of force at 15 psi on the inside)-----Do not exceed 20PSI-----. There may be profound leaking in this process, ignore it. it will only take a max of 2 seconds to straighten out. good luck, Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.