Posted by Owen Aaland on September 11, 2009 at 17:31:08 from (207.13.114.55):
In Reply to: 656 Hydro pressure posted by theponyroper on September 11, 2009 at 05:42:07:
Most likely your problem is scoring on the brass and steel plates for both the hydro pump and motor. Scoring allows oil to get between the plates and force them apart causing loss of oil pressure. They are highly machined surfaces to cleanly seal the oil as the plate turns and blocks off the holes the oil flows through.
Scoring on the hydro motor plates can cause the difference in pressure. The pump always turns in the same direction so the pressure loss should not change between forward and reverse. The motor reverses direction for reverse so it is possible to have different pressures before the plates separate.
The high pressure relief valves are pilot operated, controlled by the Foot-N-Inch valve (clutch pedal). Generally the valve will fail because of scoring and stick open. It is unlikely there is anything wrong with them. A cracked pressure line will surely cause a loss of pressure in one direction. It would be unusual to have both line cracked. Leaking check valves can also cause loss of pressure but there again it would be unusual for both of them to have failed. Both relief valves and both checks valves are the same for forward and reverse so it won't hurt to switch them. A positive check for cracked lines can be made by capping the fitting at the relief valves. You wont be able to get a pressure reading but if you drive it you can see if it makes a difference. WARNING!!! IF YOU DO THAT THE ONLY CONTROL OF THE HYDRO IS THE FORWARD/REVERSE LEVER.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
