I'll be using a Dana 60 with ARB air locker out of a Ford F350 4z4. I will need to add an "in or out" box between the right angle box and the Dana. I also intend to make the the rear drive lockable. It's a big job and it won't be done for awhile.
The right angle box is a IH PTO adaptor for mounting a belt pulley on the rear of an IH tractor. They were first used on 300-350 IPTO equipped utilities. They were also used for many years after that. Some were splined for 1000 rpm inputs. The bevel gears inside can be flipped for proper rotation.
Yep, there is chain adjustment. You can see the adjustment holes on the outside. That flange with the holes rotates an eccentric bearing carrier.
I didn't count the sprocket teeth. I suspect Elwood had many different ratios so that the transfer case would fit other "M" sized tractors, especially those without planetary rear hubs. The "W" and industrials used different differential ratios from the Farmalls.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.