Each terminal or region will have a sales staff. Call your local terminal, request a salesman, and ask if they have pallet pricing. That will be your cheapest rate. Here in New England they will allow 2000 lbs per pallet. One standard pallet should be enough.
If you are a regular customer, they will have a discount schedule attached to your account. Could be 40% or more. You probably will not be able to qualify for that. Ask the salesman to recommend a small business they ship to and from that might load your pallet and fill out the bill of lading. Or better yet, fill out your own bill of lading from the freight company's web site using the small business's account number and discount. Deliver the loaded pallet and paperwork to the small business. I suggest COD on the shipping charges. It may add $20 to the cost. You will also need to "tip" the small business.
Don't get involved with lift gates at either end. Those charges are exorbinate. Have the buyer pickup at the destination terminal or have the truck driver dump the pallet on the ground at the buyer's address. It is not likely that the wheels will get damaged.
Banding is not necessary. Home Depot has some very long and heavy-duty tie-wraps. Use a couple dozen of those to secure the wheels.
You don't need a national carrier. A regional carrier will quote the whole distance and may be cheaper.
Also look at U-Ship.com. They are an eBay company. You can post your load and destination and people will bid for the trucking. Also look at the "Hauling Schedule" link at the left side of this page.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.