Farmall & IHC Tractors Discussion Board |
Re: Head on F-20
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Hendrik on April 18, 2000 at 14:23:39 from (195.232.120.188):
In Reply to: Head on F-20 posted by superCmore on April 18, 2000 at 12:47:19:
It is of course necessary to remove ALL head bolts. The head on my super A seemed glued to the block too. What I did was making a makeshift rig, using two 5" wooden beams and a jack. I placed one (8 foot long) beam horizontally, one foot above the engine; one end rested in a window sill and the other end was supported by the other (7 foot long)beam, placed vertically and on the jack. Then I looped thin wire (normally used for baling hay) from every protrusion I could find on the head (boltheads, the manifold, etc.) and over the horizontal beam. Every stretch of wire running from head to beam was taut. In total I had about 25 gangs. Then I slowly moved the jack up and with a few (wooden) hammer blows she came nicely loose. WITHOUT putting severe strain on any specific point of the head.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|