What is sticking the rings- is it fuel gum or oxidation? If they're gummed, I'd use Gumout followed by a soak in two-stroke fuel. Two-stroke oil is pretty slippery, and the gasoline carries it into tight places well. Spraying some Gumout into the soak will help, but the Gumout in the screwtop can seems to not be worth a hoot.
If oxidation, I'd try some heat/cool cycles by heating the piston in front of the salamander and dunking in fuel oil- naturally, keep it turning so as to heat evenly in case it gets hotter than you epected. It's a good way to conveniently get a lot of hot/cool cycles in a short time. 400F or so will drive the moisture out of the oxidation. Some judicious tapping with a hammer handle will help.
You could also chuck the pistons in the lathe and cut the rings out with a HSS tool you've ground narrower than the ring groove.
As mentioned above, you can work the ends of a ring with a punch, freeing it a little at a time, flexing it as you go.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.