Jim: My 130 came new with 5:50x16 tires on cast spoke wheels. When I went to replace the rims, no longer available. (several sources I might add) One business tried to sell me blank rims and rivit on lugs from a Farmall H or 300. I pointed out to him H-300 lugs had 5/8" hole and while they were made for the 16" rim, the cast spoke center on H or 300 is larger diameter than a 130.
My brother has a 230 came new with those same 5:50x16 cast spoke wheel as my 130. I remember when those were bought new, dealer had 4 - 130 and 4 - 230 all equipped the same on front wheels. Those cast hubs are designed to take either 15" or 16" factory original rims.
I Replaced my front rims by welding a 1/2" x 1-1/2" band inside a blank rim, the fabricating lugs to weld to the band. From a distance he made it look right, up close, not so good.
I recently looked at a 79 - 140 with 5:50x16 pressed steel rims, factory original. Erik has 4 - 140s all with 16" pressed steel rims. He didn't say if they all came that way. Lot of 140s around here with 12.4x24 rears on 11" rims. It takes the 5:50 or 6:00 x 16" to make those tractors run level and look right. I have 12.4x24 on both my 130 and 140. I need that to pull that 31 row bean planter. haha
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
