Posted by athol carr on August 04, 2009 at 17:06:25 from (132.181.71.211):
In Reply to: F 14 fuel system posted by JLE on August 04, 2009 at 11:18:57:
The carburettor sits on top of the manifold with an insulating washer. If the engine is hot some heat will reach the carburettor after stopping the engine, the insulating washer is not perfect, and will vaporize the fuel. Even the gasoline engines had a heat control flap in the manifold that can be adjusted to vary the amount of heating the fuel-air mixture gets before reaching the cylinders. There were two fuel arrangments, the ones on the F-12 and some early F-14s where both fuels fed the fuel pump, the fuel from the pump went to a small vertical chamber sticking up through the hood just in front of the tank, this had a vent to air at the top, a pipe to the craburettor and a return back to the pump inlet line (this provided some head to the carburettor). The other version used on the later F-14 and all the W-12, O-12 etc. tractors had only the main fuel going to the pump and in this case the line from the pump went to T junction in front of the top of the tank, the wee upstand inside the tank gave about 1/2" head to the T, the other side of the T went to the carburettor. If it was a kerosene or distillate engine the gasoline starting tank was, in this case, set in the hood (a 7/8 gallon cylinder on its side) with two valves giving feed from the pump for normal running or feed by gravity from the gasoline starting tank for starting. If you do not have a starting tank it takes a bit of cranking to get the carburettor full if it has emptied by evaporation. There is also a fuel filter built into the inlet to the carburettor and if this is blocked then you could crank for ever!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
