Thanks again for all your help, I really appreciate it. I just want to make sure I'm using this thing in the right manner- not that it seems to be doing any damage to run it the way I am, but just so it's correct.
My current setup is as follows: * Single line from Lift-All output on right side of tractor to the left side inlet on the Remote Control valve assembly * Single line from upper (pressure) rear port on Remote Control valve assembly to break-away, then to hydraulic tee * Two single lines from either side of the above tee to the pivot-side ports on two double-action cylinders on the 3-point hitch * Two single lines from the piston-side ports of the above cylinders to a hydraulic tee * Single line from hydraulic tee to a breakaway valve, then on to the lower (return) rear port on the Remote Control Valve assembly The two Lift-All ports on the left side of the tractor are capped, as is a port on the right side of the Remote Control valve assembly.
As I mentioned, I have the Operator's Manual for the M as sold on this site, but the pictures are very grainy, and do not clearly show the routing of the hydraulic lines, especially as pertains to the Remote Control valve assembly. Your diagram seems to make sense for a single-spool double-action valve like the one you show, but that doesn't help when I'm trying to figure out this Remote Control unit.
I just went outside and took some washed-out pictures of my hydraulic setup with our old digital camera, but cannot find the cable to download them! Once I find that, I will post them to my Photobucket site and will post a link here.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
