Posted by mattofvinings on August 01, 2009 at 09:32:20 from (75.131.212.224):
In Reply to: farmall M rods posted by LN on August 01, 2009 at 09:06:06:
My opinion is that the "flex-lock" nuts used are a step ahead of simply torquing to spec as they also provide added resistance to vibration.
Best practice, IMHO would be to use a torque-prevailing nut (also called deformed-thread) and set a couple up, cross-drill the free end of the bolt for safety wires once they are fully torqued.
IIRC they are fine-thread and so if possible you will want a "graded" nut as well to make sure the threads simply aren't torn out of the nut under loads.
While what I'm describing is probably somewhat overkill for an engine turning no more than 2200-2400 rpms max, at the same time I don't think any of us can afford the downtime or expense of the lower end of an engine coming apart.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.