Posted by bc on July 22, 2009 at 22:01:13 from (71.158.222.210):
In Reply to: IH 656 gas posted by hoppy50680 on July 22, 2009 at 16:23:25:
I would ditch that solenoid and put in a needle and packing. My 2606 had the old adjustable solenoid that the adjusting screw was stripped out and the wire was long gone with the guts all rusty. It was adjusted by putting an oring on the threads and then screwed it in/out for adjustment. I believe it was the 656 gas version on the caseih.com website where I found the part numbers for the needle and packing. I left the same seat in there.
I suspect when you poured the gas in, you stirred up a bunch of rust in the bottom of the tank. Check the archives to fix that with your choice of options. Your fuel line may have a screen at the carb. You need to pull the fuel line and and run a full stream for 5 minutes into a hose and gas can to know you don't have a fuel problem. The top of the sediment bowl above the screen can fill up with rust and block your flow without necessarily any going into the bowl itself.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.