Posted by Janicholson on July 21, 2009 at 18:24:48 from (64.61.212.178):
In Reply to: Re: Farmall M clutch posted by jeff338 on July 21, 2009 at 08:03:02:
Because the system is still accessible, I would probably take out the three bolts and install them in the three holes. If they in deed do the release thing, I would then spin the input shaft to see if there were interference with the F/W bolts. If it is smooth, and the bolts move the lever about 1/2 to 5/8" farther than the "flat" you indicate, I would believe the clutch and PP are OK. People have done two unfortunate things (really more, but these are common) to clutches. One is to cut the linkage shorter when the adjustment runs out, and the other is to cut the mounting surface of the FW to allow the disk to be pinched harder. This requires removing the F/W (a split) so would be more intense than a new disk. It could also have been machined wrong. I do not know the step depth of the F/W, but it is available, and easy to measure. On most new installations the fingers are almost always near flat when installed. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.