Allen, you are talking about removing the 3" long bullplug that is at the top of your picture right?(your picture looks at the housing from the passenger side rear wheel with the front to the right)
On my 2606 industrial, it doesn"t have all the guts in there but the long bullplug screws into a hole directly under the round flanged casting about where the rust spot is in the casting. I removed it to get the oil level down a few inches and cleaned out the sludge in the bottom at the same time.
Mine also has a open top round metal tube stand pipe in bottom left corner in your picture (which I can"t see so it must be under the oil) which basically keeps fluid a certain level in the housing to keep parts from rusting (I guess). However my metal stand pipe is welded to a plate that bolts up to the housing from the rear end side. There was no easy way to remove that stand pipe without a sawzall or hack saw blade so I left it.
By the way for inquiring minds, the oil inlet for the housing is just above the pressure relief valve in the lower right hand corner. The oil comes in down towards the bottom of the cavity and from the block that is attached on the outside of the housing to the right of the pop off valve.
That pop off valve in the bottom right corner was what I found had a piece of metal (maybe part of the broken spring) that was holding the ball open. I"d run the tractor with the cover off and oil would just come bubbling out of it. Put it in a vise to push the ball in and the metal piece that was about a quarter inch long fell back inside the valve. I"m keeping an eye on it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
