Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Tractor fuel.


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by Bob Kerr on July 09, 2009 at 10:31:46 from (216.249.86.199):

In Reply to: Tractor fuel. posted by spiffy1 on July 08, 2009 at 19:52:59:

I ran my 29 10-20 on kero and it did fine. I know the 22-36 has the water injection set up to keep the mixture from preigniting and causing pinging. The 3 HP and larger stationary engines like the IHC M 3hp also has water injection for use when running kero. That said, I think IHC was more concerned about the carbon in the larger engines glowing and causing the pinging more so than high compression causing the ping. The steam from the water in the fuel mix would douse the glowing ember. If you do run kero you must cover the LOWER part of the radiator to get the water temp up to prevent oil dillution. I found that if the lower water return elbow was good and warm to the touch it would be ok and not cook the head. Be sure to use good sae 30wt or 40wt oil. straight 50 wt would be better if it will be running at very hot temps for long periods. Those engines will run on diesel oil ok BUT the pariffins will gunk up the spark plugs and also cause exess carbon in the cylinder head to build up. I knew a guy in Oklahoma whos Dad ran straight crude oil from the test cock on a well in their 10-20 when he couln"t afford regular tractor fuels back during the depression. It did ok but he did have to clean the spark plugs at noon and in the evening because they would gunk up. I also ran my 35 F-12 on kero and did a HP test on a dyno. I did a comparison test for kero VS gas. The HP was the same at 13.5 for both fuels, but on the kero run I did have to lean the carb a bit so the HP hours were better on kero. When I would first start my 10-20, one full starting tank of gas was barely enough to get the engine warmed up like it should to run kero so keep that in mind. One last thing, when you run kero or anything but gas, be sure to let the tractor sit over night and let any kero float to the top of the oil and drain the oil from the middle valve on the oil pan. then refill with fresh oil to the top valve. Even if ran hot, there will be some dillution. I ran plain old kerosene and it smelled different enough to get people talking about what fuel I was using. If you see white smoke the manifold is too cold and is dilluting the oil.


Replies:




Add a Reply

:
:
:

:

:

:

:

:

:

Advanced Posting Options

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.



 
Advanced Posting Tools
  Upload Photo  Select Gallery Photo  Attach Serial # List 
Return to Post 

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy