Posted by dave.koenigsfeld on June 30, 2009 at 15:31:11 from (148.78.54.134):
I needed a more concrete friendly steel wheel for my 1925 McCormick-Deering 10-20. I wanted to keep the original wheels just in case and did not want to remove the cleats.
I saw a design that was similar in a book. I had a local metal guy fabricate 1/4" steel bands with brackets. We used the original bolt holes to bolt the bracket to the wheel and welded the bracket to the band. I glued a 1" thick piece of skirtboard to the band. The band also has bolt holes in it every 12" so I can bolt the rubber to the band.
At the seam of the band, the band bends 90 degrees down for about 2" and we bolted the band tight there.
I had them sand blasted and powdercoated. I think they came out great and maintain the cleat look as best as possible.
Now I need to get it running....that is another post.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.