Posted by pete 23 on June 26, 2009 at 20:42:57 from (173.87.14.132):
In Reply to: 350 hydraulics posted by Bob 02 Martin on June 25, 2009 at 19:17:02:
Yes, a new perfectly manufactured spool type valve as used in the 350 will hold a load in both directions (up to a point) and that point is when the pressure required to hold the load and viscosity of the fluid reaches the point where fluid will leak through the clearance required to allow the valve spool to move freely in it's bore. A worn spool or bore will leak that much sooner. Like Dick said, that is why IH used a check valve on the hitch and made them available for the other valves as well. Some were single action, some double, and some were alternating check valves. One of the major complaints against IH by John Deere oriented customers over the years was always that IH tractors always allowed hyd cyl's to settle. Deere SCV's, had a positive seal and that is why you saw high pressure safety relief valves on deere cylinders as they would blow cylinders and hoses when parked out in a hot sun and the IH would not as they would seep enough to relieve the pressure. I found out the last few years I worked at a Deere dealership that this positive seal feature was very expensive to maintain as I repaired a quite a few SCV's and it was a money making deal for dealer. Could have bought a new aux valve on the IH for what was put into them as a regular repair. The thing I always like about a spool type valve is the control you have when inching a cylinder into a load and you don't have that precise control with a poppet type valve.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.