Posted by MHMalcolm on June 26, 2009 at 13:34:28 from (66.66.148.252):
In Reply to: Re: 350 hydraulics posted by pete 23 on June 25, 2009 at 20:50:59:
I second everything Pete 23 said. I would take off the mower and lower the hitch all the way to the ground, and check which hose seems like it is pressurized when you hold the control lever in the "lower" position. Shut off the engine and stick a jack under one side of the fast hitch to raise it just enough to take the pressure off the cylinder. Then disconnect the hose that DID NOT pressurize from the fitting on the cylinder and point it into a bucket or wire it to the tractor so it is pointing down where any oil coming out of it won't hurt anything. Connect a short hose, if you have one, to the cylinder fitting and point it where any oil coming out of it won't hurt anything. Start the engine and set the throttle at idle. Slowly push the control lever into the "lower" position. If any oil continues to flow out of the cylinder with the lever held down, the O-ring on the cylinder piston is blown, and you will have to disassemble the cylinder to replace it. I would bet that is what is happening on your tractor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
