Posted by Mike CA on June 15, 2009 at 22:57:27 from (99.28.152.102):
I got a 12v genny from an MD. I swapped the belt pulley. I also got a new generator mount because the one that came off my tractor was drilled out... I'm assuming to move the generator forward. So, with the new genny, and the new bracket, with the old pulley... It's too far back. (see first pic below, you can see the second pulley below. It's out of focus, but it should show you how the belt line is off). The pulley seems to tighten on, and that's it. I don't see a way to adjust it out farther.
The only adjustment I see is the bolt and screw that allow you to adjust the width of the rear pulley guide. (see second pic)
So, I'm clueless on how to get this thing pulled forward. I'm assuming the two pulleys are supposed to be completly in line?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.