First of all The lights working and no amp gauge movement means either the amp gauge is stuck (frozen), or wired incorrectly. The lights should be wired through the amp meter to the starter switch then to the negative post of the battery. Thus when the lights are on, the amp gauge moves. The fact that it does not tells me that you may be in better shape than you thought. With it running at 3/4 throttle or above, test the battery voltage with the switch set at the second position from far CCW. This is the high charge position. It should show about 7 to 7.4 volts across the battery terminals. If it does, you are charging correctly. Turn the switch to full CCW and check the volts. 6.5 to 6.7 are good numbers on Low charge. Turn the switch to D (third from full CCW) and the voltage should be same as in the High charge position 7 to 7.4 volts. If so this indicates that the light resistor is open (bad) or the light switch terminals are not making contact on Dim. If the voltage is OK, I would check the wiring against Bob M's Diagrams and if OK, I would replace the amp meter. Let us know what you find. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.