MKirsch: I got an e mail from a New Englander couple days back, and his first reaction, "Why didn't I think of that in the past 45 years?" I responded by telling him it took me 45 years. Bear in mind I didn't have lot of time to put into the hitch until I retired.
I built my first hitch on my 130 in the mid 1960s to operate a Deere 246 corn planter. At that time I used same basic design as Worksaver, with lower links hooked directly to final drive. Those lower links were about 6" shorter than the 32" ones I'm using today. It was very difficult to lift the planter loaded with seed and fertilizer. The biggest problem was getting the corn planter to trail centered on tractor, lower links too close to parallel. When I set the top link to control depth of corn planter, the planter would flop to one side or the other and not trail true. I'd have a 20" row on one side, 30" in middle and 40" on the other side. Very quickly I found a fast hitch fork and almost as quickly some fabrication and a one point fast hitch Deere corn planter.
This never mattered much when I was farming. Over the years I built a couple other devices which plugged into fast hitch and would hook to a 3 point hitch implement. Problem with most of those, weight was too far from tractor.
Back about 4 years ago I lugged home a MF-25 disk with 24-18" blades. I thought about converting it to fast hitch, decided I'd ruin a good 3 point disk. That is when I decided on this hitch. There were a few design ideas went to the scrap pile. Finally a hitch that would lift that 1,000# disk, and I could pull it if I didn't get too vicious on angle of cut. It took the hydraulics very close to their limit, wasn't something I wanted to use long term. I sold that disk and bought a 20 blade, 18" blades, bit lighter as well. One item I've discovered, my 130 and 140 each lift more weight via 3 point than 1 point.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
