The rod that controls the Liftall passes through a slot like cast arm on the steering post. This bracket is used to hook the rod in the hold position. The small welded on stop on the under side of the rod is hooked on the slot in the bracket. (there is supposed to be a flat spring on the bottom of that slot, that holds down on the rod but many are broken) The rod pulls farther to lift, and back to the stop to hold, and lifted and pushed farther to lower the load. I am concerned about the rear left outlet. It should be able to be tightened into the housing (inside) to prevent leakage. it is just Pipe thread. If turning it CW never tightens it, the pump will need to be removed to fix the threads. It is under pressure when the rod is pulled (delayed, but still pressurized. The pump comes out easily (but awkwardly) out the bottom. The cover plate is removed, the cotters in the pump drive shaft removed, then the drive shaft. The pipe fittings and cap and lever are removed, and the 4 bolts holding it up are loosened, not removed until ready. The pump is heavy and needs a floor jack, and two people to lower it. Threaded rod in the bolt holes and nuts to lower it are slower, but safe. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.