Hank: Most IH tractors from that era had the serial number on the clutch housing.
Here is my argument on the issue of disbelief. IH built Hi-Clear models of most Farmall two wheel drive row crops. This was done by either a drop final drive or in the case of the offsets much larger rear tires. Front ends were all done using either larger wheels or front ends with longer spindles. Most of this was done on two wheel drive tractors, and most under 100 hp.
There were a few 4 wheel drive tractors under 100 hp with larger diameter wheels front and rear.
When one gets into the big 4 wheel drive tractors, mainly intended as a draft machine, usually big wide tires were the order of the day. It becomes quite easy to put large diameter wheels on the big articulateds, as the wheels always stay inline with the chassis. All one needs is long enough wheelbase so front wheel don't hit rear when turning.
The 4100 is rather a unique animal, rather than articulation, IH used two steering axles on a solid end to end chassis. Much more than a 6' diameter wheel and wheels would strike chassis when turning. I rather doubt that a drop final drive could be engineered to work on steering axles. Massey Harris did it in the 1930s with their GP, but that probably only generated 35 hp.
The IH 4100 is 150 hp, built for drawbar lugging of plows, disks, cultivators, chisel plows, etc. If they built a Hi-Clear 4100, I'm sure most of the old hands here at YT would love to see a photo. I know I would. So, could you just fire up the family buggy and drive that hour for some photos.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
