Posted by D Slater on June 07, 2009 at 06:34:22 from (72.65.130.133):
In Reply to: Farmall Super M Head posted by IH-Mitch on June 06, 2009 at 18:57:05:
If its a gasoline fuel head look for a casting # on top of head. Some late 52 M and W6 tractors came with the same head as SM,SW6, SW6TA and SMTA came with. Numbers 8060 DC or 8574 DB. later head numbers 8060 DD and 8574 DC would be good. Most other M heads with a lower ending letter suffix will work. Number series tractors gas heads for 400 and 450 will also work, but require a top end ventilation change, most times are higher priced and will raise the compression. Almost all heads from M to 450 will bolt on and can be made to work, performance of tractor will not be the same for some of them. When looking for a head its best to go by the casting numbers, I would guess over half the tractors mentioned above don"t have the same heads that came on them. If your SM does I agree with James, if the crack is in a repairable place it may be best to have it repaired at a place with a good reputation unless you find a uncracked one for less.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.