Posted by mattofvinings on June 06, 2009 at 16:37:24 from (67.142.161.33):
In Reply to: hyd cylinder 2350 posted by Mike186 on June 06, 2009 at 11:43:26:
Just a couple of generic observation from rebuilding other types of hydraulic cylinders...
....if the rod chroming is rusted or chipped it will eat the u-cup rod seal in no time at all. Best you can do with a mild case is to use something like a 600-grit diemaker's stone to smooth over the rough spots. Worse than that it's time for another cylinder or to have the rod refurbished, rechromed and ground back to size
...if the rod is bent or the internal bushing which centers the rod is worn oversized then the seal will never work correctly. Same condition can apply if the hydraulic cylinder isn't "floating" on the end-pins and the rod is "side-loaded".
....I don't know if you used a rod scraper in your kit (I assume so for outdoor/off-hwy cylinders) but this is an important piece, as it excludes as much debris as it can from the more sensitive u-cup which is actually doing the sealing. The grit will abrade and damage the u-cup. An aside here, often outdoor cylinders can get water in them over time, simply from being outdoors, condensation, etc, which can get rust in the seal glands. If this isn't cleaned up at the time of rebuild, one of two things can happen, a) the loose rust can act as a lapping compound to eat the seal, or b) the "gland" or groove where the seal fits in can get rough and oil can leak behind the "back" side of the seal.
....also any o-ring which seals the endcap of a cylinder (in order to remove and assemble the piston) can also have issues which may appear as a leak at the rod packing. Good to wipe everything clean with solvent and then start carefully testing under pressure so you know exactly where to go looking.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
