Assuming you have the engine-driven pump, and the factory "christmas tree" valve here's how the hoses go. It's really quite simple. You work in complete loops. The easiest thing to do is put the second valve in the loop first:
Loop #1:
1. From the pressure side of the pump to the second valve IN port.
2. From the OUT port of the second valve to the IN port of the factory valve.
3. Out the bottom of the factory valve back to the fill pipe of the reservoir.
4. From the drain port on the reservoir to the suction side of the pump.
Loop #2:
1. From one WORK port on the factory valve to a T fitting.
2. From each leg of the T fitting to the bottom ports of the lift cylinders.
3. From the top ports of the lift cylinders to a second T fitting.
4. From the second T fitting back to the other WORK port on the factory valve.
Loop #3:
1. From one WORK port on the second valve to a T fitting.
2. From each leg of the T fitting to the bottom ports of the bucket cylinders.
3. From the top ports of the bucket cylinders to a second T fitting.
4. From the second T fitting back to the other WORK port on the second valve.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.