Posted by P and R Pete on May 31, 2009 at 08:56:53 from (173.86.0.139):
In Reply to: Hydraulic Leak posted by Farmall Bob in CT. on May 30, 2009 at 17:51:28:
Farmall Bob,
Here's some pics of mine, on a Super-A, and I don't know if the same pump and arrangement is used on a Cub, but the principles should be similar.
Here's my pump as it sits on the lower right engine case- you can find yours by following the hydraulic lines. My pump body separates into 2 pieces, and the offending O-ring (or seal,- different pumps used different ways to hold the hydraulic fluid) is in the front part of the body, arrowed.
Once off, here's the gear that extends into the engine case and is driven by the cam gear in the engine, and here is where your fluid is getting past and into the engine. The arrow points to where the washer under the nut was bent up, to act as a 'lock' on the nut.
Here's mine in pieces. (Warning- if you're going to take yours apart, make sure you have things go back in exactly from where they came out) As you can see, that outer gear is keyed, and needs to come off to extract the shaft (black arrow) on which it rides. The worn O-ring/seal is in the bore labeled #2. What CNKS was referring to is that the old O-ring/seal often wore a groove in the shaft, and you would see that groove where arrow #1 is pointing. A groove will promote leakage on your new O-ring/seal, so you don't want to miss it.
I'm holding the re-build kit I got from IH. It contains instructions with pictures. To get the right kit, you have to find the serial number on your pump. Mine was long, but very small, and I had to scrape paint to find it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
