Look up on your motor, at the top edge of teh block and just below the #1 plug. Thre will be a serial number there that, if it is the riginal motor would, with a very few exceptions, match the serial number of the tractor. Still there are a lot of tractors out ther that have had the motors replaced, so that's not always reliable.
There are also the date codes in some of the castings, like your crankcase, torque tube, transmission case, even the cast wheels. These will usually have what looks like a strip with screw heads in the casting, in a format ##-##-X, where #s are numbers indicating month and day, X is a letter indicating the year (I for 1939, running sequentially up to Q for 1947, the last year the Bs were made) and the dashes being the screwheads. If everything is original, all the dates you find on your tractor whould be within 6 months or so of each other (wheels are a common exception to that assertion, so concentrate on the chassis). If a lot of the dates are in the last three months or so of a year, there's no way to tell without a serial number whether it was assembled and came off the line late that year or early the following.
So that's when you go back to that number you find on the motor.
Take that number and check it against the serial numbers you'll find at the link on the left side of this page. If your casting dates are consistent with the date of the serial number you find on the motor you can be reasnably confident of the year of your tractor.
My BN has both serial numbers still on it, but assume the chassis serial number plate were gone. The number on the motor is 1190XX which would make it a '47. That's consistent with the Ps and Qs in the casting date codes, and I'd be fairly confident that it was a '47.
There are exceptions, but check it out at least that far and let us know if you have any questions about what you find.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
