Farmall & IHC Tractors Discussion Board |
Re: Oil pan on 70's IH diesel
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by 80 Grit on April 11, 2000 at 13:22:36 from (206.228.214.89):
In Reply to: Oil pan on 70's IH diesel posted by Cliff on April 10, 2000 at 23:03:52:
Cliff, you have a couple things confused. The vacuum is created in the cylinder chambers through the pistons and valves actions. A clogged inlet filter would affected this. The crankcase sees the blow by from compression and would be slightly positive. The crankcase is not very well sealed and if for some reason an excessive vacuum or pressure could occur the seals at the front and rear of the crankshaft would vent the crankcase along with the oil filler cap, the vent tube and the oil dip stick tube. The damage you are seeing on the pan could be from internal breakage resulting from a broken connecting rod or could be from external causes such as improper jacking or dropping the tractor. Since you stated that the tractor had run hot, it probably has rod problems. Better leave the machine for an experienced mechanic with deep pockets.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|