Posted by Randy-IA on May 18, 2009 at 19:14:10 from (207.177.83.85):
Hi, Plowed for a couple of rounds with the M pulling 3-16's. In some spots that were drier it pulled great but as it got wetter in spots I just spun to a stop which is not so good with a clutch lift plow. I didn't get in enough rounds to put a high polish on the bottoms, just to wet to get traction with no weight on the tractor. They had very little rust on them since I plowed with it last year just not enough to get a good polish then either. I gave up with the #8 and M and went home and got the Oliver with the 565 4-16 semi-mount. Plowed about 15 acres with it though muck and sometimes mud. Altogether I got about 9 hours of plowing in. It was a great day! Half mile pulls. 85 acres. Two tractors. Clover as green manure. I just wish I had more weight on the M. How much is needed as a rule for 3-16's and/or 4-14's? I also have a #8(?) hydraulic lift with 4-14's. Will the M pull that with enough weight? With you not knowing the soil types around here could you make a good guess? Thanks! ...Randy
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
