Posted by Owen Aaland on May 08, 2009 at 22:14:56 from (65.165.246.54):
In Reply to: changing an H axle posted by Brad in WI on May 08, 2009 at 20:51:09:
The four bolts on the outer cap are what hold the axle in place. The easiest is to leave the wheel on to start with. Take out the four outer bolts With the tractor blocked up so you can turn the wheel, use a wrench through the PTO opening. Turn the wheel to loosen the bull gear retaining bolt. Once the bolt has been loosened, use a spacer between the two bull gear bolts and continue the turn the wheel to unscrew the bolt. As the bolt unscrews it will force the axle out of the bull gear and inner bearing. It will also push the outer bearing out along with the axle. When you run out of threads, if the axle is not loose enough to pull out, you can remove the heavy washer and screw it back in the axle, use a longer spacer or a longer bolt and repeat the procedure.
Going back together, block the bull gear up so that it is centered on the inner bearing. Leave the outer off the axle. Run the axle through the inner bearing. you can move the outer end around a little to help line up the bull gear. Once the bull gear is started on the axle you can use a longer bolt in the end of the axle to bull it together enough to get the original bolt started.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.