Just quickly...the Mobil 600W steam cylinder oil is a worm gear lube for when bronze is present. The EP additives in a "rear axle" oil ala 90W or 85W140 or the like are for steel on steel and will slowly break down bronze.
Mobil has started spec'ing SHC634 as a replacment for the 600W in some applications.
Next I'd look at a #0 or #00 grease. We used #00 grease in 5-axis robots I worked with, the motor had a spline machined into the servo motor output shafts and these mated with an internal planetary setup. This style of grease could still be "placed" like drywall mud but was much softer than the standard #2 grease we get out of tubes.
Another thought is to get a couple bottles of STP oil treatment...that stuff is viscous! I'm not sure how it rates as a standalone lubricant...but thick it is...
This post was edited by mattofvinings at 10:11:44 05/07/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.