Chris: Crawlers especially big ones should only tow heavy equipment. Young lad I had spreading manure, got 1066 down with duals just as frost was coming out. He wasn't down that bad, but he was on frozen soil. With water saturation in the soil above the frozen soil, may as well have been pure ice. 12 ton flotation manure spreader behind.
Since he was alone, forestry skidder was not near, he took the Cat D7 and two new 3/8" chains. He broke both chains, and what I had left was 4 push poles. The annoying part, he drove the D7 right past a 1" cable with tow hooks. I think he got so excited about getting a crack at driving the D7, all else was forgotten.
Hardest pull I ever made in my life was D7 down in a peat bog over it's tracks. We got a cable attached to it's drawbar. 200' away was a 6' embankment. I put the Deere down over that bank, with rear against bank. We put a 4' diameter yellow brich under the cable about 25' from the D7. That was designed to lift. Then we backed 1066 in front of Deere, drawbar over the logging blade, chained the two together. The front end will come up on those big skidders if pulling hard enough on winch, and back wheels can't slide.
I wouldn't let anyone else make this pull. I set the throttle about 1,200 rpm, started winching. It was damn uncomfortable listening to that cable wrap on the winch spool right behind me. Pulled the 7 out, 1" cable didn't break, however it wasn't worth a damn after that pull, almost like a long 1x4 board to handle, wouldn't wrap on winch spool unless it had load. The part of cable that was on spool during pull was almost like the coil spring of a 58 Buick. Two men couldn't pull it straight, and the straight part of cable was terrible if using fairleeds to hook up several logs not in a straight line. Needless to say the operator didn't tolerate te cable very long skidding logs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
