I don't think there is room to replace the front transmission seal without removing the clutch shaft. To remove the clutch shaft, you will have to remove the hydraulic Lift All. If the bolts that are loose are the four bolts in the main drive shaft coupler, it could mean the holes in the coupling plate are wallowed out and you may need a new plate. Those bolts are tapered shoulder bolts and should be wedged solidly into the coupling pieces that are on the shaft. The transmission seal runs on the coupling piece, not on the shaft itself. It is retained to the transmission input shaft with a bolt and is keyed to the shaft. Not usually to difficult to get this off, but I don't think there is room to get it off without removing the clutch shaft which as I said before will require that the Lift all be taken out. If you can move the transmission input shaft up and down with the clutch shaft, then you are going to need new bearings on the input shaft as well as a seal. Also, you will likely need new rubber washers for the coupling.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.