Posted by the tractor vet on April 14, 2009 at 07:02:27 from (76.212.233.212):
In Reply to: Re: pto problems posted by davin003 on April 13, 2009 at 19:53:59:
Well , I told ya all that i can as there is not much to them units so if everything is as it should be and the pick up tube is snug in the clamp the tube does not have a flat spot and in the correct position and does not flop around as this will cause the seal to suck air as it just sorta sets in the bore and the pump is good ya got the valve put back together correctly don't know what else to tell ya as like i said i CAN'T see it. It takes me about two hours from the time i start with draining the oil to the time it is running in the tractor again. Did ya check the brake piston's ? last thing as to where the oil pressure could get dumped . Oh if your going to replace the teflon seal rings on the clutch drum it helps if ya soak them in hot water - oil to warm them up then use a piston ring compressor to shrink them back into the seal ring groves . and be care full when reinstalling the clutch drum back into the housing so not to damage the seals . I use white grease on theses .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.