Posted by John T on March 03, 2009 at 08:49:51 from (71.55.26.69):
In Reply to: no spark! posted by Willbur on March 03, 2009 at 07:29:17:
I agree with Jimbo... There should be near full battery voltage on the coils input (from battery/switch) and over on its output (to distributor) there should be near battery voltage with points open but near ZERO when they are closed.
If theres only like a volt or two on the coils output (to distributor) when points are closed Id suspect burned/corroded/carboned/pitted resisive points but if theres like 3 to 8 etc the points must be really really badlyyyyyyyy burned and/or not fully closing cuz the gaps set too wide. If theres less then full battery voltage at the coils input when the points are closed and the coils conducting current then Id suspect a bad resistive ignition switch contact but that shouldnt be the case when shes hot wired correct
Put a 12 volt test lamp on the coils primary output terminal (one to distributor) and as the engine is cranked it should flash full bright ON when points are open but go dead OFF when they are closed......Shes never gonna fire until the voltage on the coils primary output (to dist) terminal) is on and off i.e. test lamp flashes on then off as engine is cranked.. If it never comes on, the points arent opening or the condensors shorted (or a wiring short) or the coils primary is open........If it never goes off, the points arent closing or are burned/pitted or the points or dist isnt well grounded or the wires open
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.