F-Dean said: (quoted from post at 11:44:59 03/01/09) On my M, which should be similar, I installed the clutch and then adjusted the fingers to all be the same distance from the throw-out bearing -- after I had adjustd the clutch linkage so that the throw-out bearing would be as far back as possible. My logic was to have them all (3 on a M) release at the same time and rate.
If you adjusted them to be as far back as possible you will not have any adjustment for free travel as the clutch wears. As the disc wears thinner the levers will move back farther.
A properly adjusted pressure plate assembly should have the levers about parallel with the friction surface of the cast plate with a new disc installed. Unless the PPA has been disassembled for service you should not have to adjust the lever height. When properly rebuilt they are adjusted to a couple of thousands of an inch, much closer than you can get adjusting then installed in a tractor. Unless something is worn out or broken this adjustment should not change.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.