Below is my reply to Henry's post which is not accepting replies:
-----
Henry - Since your loader has 2-way (push-pull) lift cylinders, you can get by with less reservoir capacity than if it had 1-way (push only) cylinders. However even with 2-way cylinders there will still be SOME net movement of oil out of the reservoir when the cylinders extend. The oil volume reduction will be equal to the displacement of the cylinder rods.
If your tractor’s existing reservoir capacity is inadequate for your loader it’s not difficult to add a 2nd, auxiliary reservoir then tee it into the pump suction line. It can be mounted most anywhere, but at or above the level of the pump is preferred. The reservoir connecting line should be the same size as the pump suction line. Also it must be well vented with the vent protected with a breather/filter to keep dust, etc out.
----
Personally I prefer a loader with down pressure. Down pressure makes the loader much more versatile for everything from pushing posts into the ground to lifting the tractor’s front end to change a tire.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.