Posted by Eric Skokan on February 23, 2009 at 15:55:00 from (71.212.136.110):
In Reply to: Re: Farmall B Timing posted by Bob on February 23, 2009 at 09:32:32:
well first a friend and i made a crank because there was none when i bought it Then I reset the rotor spindle to the mag gear lining the R on the rotor spindle to the notched tooth on the mag gear (because the rotor spins clockwise) I hand cranked the motor to tdc on compression stroke Then I replaced the cover, rotor, cap, etc. But no dice. It doesn't fire.
So, I pulled the #1 plug and turned it over to see if it would spark. But no spark. (does it have to be grounded really well or perhaps not at all?) I just layed it on the govenor.
I'm wondering which direction to look next. I'm thinking I either did a poor job of finding TDC and have the timing wrong or somehow I've caused the magneto to not generate a spark. How does one test a magneto for spark independently of the timing of the engine? Also, I've noticed that the magneto wants to trip a few degrees after where I think TDC is. Is that normal?
By the way, thank you all for the help thus far. I am very greatful.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.