Posted by Janicholson on February 18, 2009 at 06:35:42 from (199.17.6.128):
In Reply to: Re: MD Questions posted by D Slater on February 17, 2009 at 19:33:51:
I have no flame, but it is fun to discuss. The mixed air and fuel on the Gasoline operation mode run through the same intake ports in the head that the air enters in the diesel mode. The Third valve is always open, in gasoline mode, without "seat" time to cool it. The gasoline compression relief chamber and spark plug are cooled to engine operating temp for the casting during operation such that the hotest element in the chamber would be the back of the compression relief valve. A gasoline operation has flame fronts extending all the way to the edges of the entire combustion area including the compression relief area. This flame front burns until it is quenched near the boundary of the cold (relative) combustion chamber and prechamber and compression relief chamber. The diesel flame is concentrated in the area of the prechamber and the hole leading to the top of the piston/valves. My true impression includes the idea that a post diesel run of a few seconds hurts nothing, and might (might) clean the spark plugs a bit from the start cycle carbon that could be there? I was told by the man I bought my 48 MD (with a shutoff button, but distributor coil ign 12 volt.) that he ran it at max output for its entire life on a irrigation pump, and that it had litteraly no wear on the drive train. (in 1997 and 98, it still had 1/2 worn original tires on it. It was shut off after as much as 75 hours of full output operation by running it at idle diesel for 5 minutes, then just closing the diesel speed control. It never had the head off of it as far as I know. Good discussion, JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
