Posted by Jim Becker on February 17, 2009 at 08:19:50 from (71.252.139.51):
In Reply to: SUPER A AXLE SEALS??? posted by NC-SUPER-A on February 15, 2009 at 21:35:31:
HTH you were on a good track with the R91 theory. Unfortunately, IH considered lip seals to be assemblies. Under the R number system, they are pretty well all R9x.
Here is the process I went through:
I found the same 3 numbers in the Super A manual as the rest of you. Thought the 140 may have essentially the same seal with a newer part number, since the manual was newer. Found the number 273563R91.
Then went to Messick's and typed in 53599D. They said superceeded by 38220R91. Clicked on that number, and they listed all the above numbers as superceeded by it (at $12.xx).
On a hunch, I checked that number in the ATIS Cub FAQ. Found the same number listed for the same application on the Cub. Listed cross references:
Federal Mogul 472070
National 14702, 472070
CR 18104 (use 2)
National 470267SSR
CR 512309BT
These crosses are what various CUb owners have found that worked for them. I have found CR 512309BT in an IH reference. Check the dimensions, but that is probably what you need.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
