I do not think that you are going to like what i have to say here . First off the hot oil pressure is on the bottom of the totem pole (not good) from the looks of th plugs yep ya got oil COMING UP not good . Doing a head job is not going to cure this . With low oil pressure the bottom end is just about toast so ya are going to probable need bearings and more then likely regrinding the crank , also new cam bearings . On the oil pumping i would have to say that either ya have scored liners and pistons on the holes in question or stuck oil rings. This is cause by running reg gas and causing the pistons to swell So i guess you are looking at a total out of chassie rebuild . If you want life out of any of the later 4 cyl. and 6 cyl. gas farmall this is what ya have to do . 1 ya run high test , 2 ya run low ash 30 weight oil 3 ya run the plug that was meant to be in it as to the heat range. , 4 ya set the ing. timing to spec. and check it with each and every point change. , 5 ya make sure that you have good fuel flow from the tank to the carb and never put a inline filter in the line the screen in the sediment bowl will get the job done and make sure that ya keep that sediment bowl clean of water and junk. Keep in mind that these tractors were build when gas was rated 95 octane for reg. and the min. fuel requirement for these engines is 93 . If you decide to rebuild then there are things that you or your machine shop need to know and i can help on this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
