I agree with The Vet there CNKS. Proper ignition timing cannot be done by ear. I have seen those who have tried. They sound good, but run poorly when put under a true load (close to rated engine load). May it be a simple 4 cylinder engine, an inline 6 or a fire breathing V-8, put a light on it. An advanve type is not nessecary but is a nice feature. If ya do not have a timing light, buy one with the advance built in.
Back in HS a buddy had an 87 Dodge with a 230 slant 6. They tuned it by ear and at idle and at higher RPM's sounded dang good. If ya punched it going down the road it would fall on its face. Put the light on it and it was about 20 to 30 degrees out of spec... After putting the light on it the ol Dodge ran as good as a Dodge could :( It was still a Dodge :lol:
Do not get me wrong CNKS, you bring a lot of good info to the Farmall and Paint boards. You are quite knowledgable, but one cannot properly time an engine by ear.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.