Posted by Wild Bill Caldwell on February 04, 2009 at 20:28:46 from (65.0.46.29):
I've never seen this discussed on this forum....How do You judge good workmanship when You look at tractors that have been restored, or worked over, or worked on, or so on? What defines sloppy work versus Field expdiency? What do You think of steel fuel lines being replaced with stubs out of the sediment bowls and carb. with rubber hose and hose clamps between. I know how to judge firearm work, I have studied Jap. swords, engravein', buildin'guitars, I can inspect weldin' but what is the criteria for tractor work. There are times I've been at a tractor show or pull lookin' the tractors over and hear critical comments from others, have had a few confrontations from takein' exception to comments I didn't think was necessary or proper, it is easy to be critical of a Hand when You ain't the one A$$ deep in Bullagators lookin' for the swamp drain plug...You hands on this forum are some of the sharpest I've seen, I 'd like to know what You look for and over look
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.