Posted by ScottyHOMEy on February 04, 2009 at 06:46:47 from (64.222.201.63):
In Reply to: Super C Governer posted by Dustin Hartmann on February 04, 2009 at 06:05:14:
There's a number of things that can cause that.
I've found it to be pretty common with replacement and rebuilt carbs when the arm on the throttle shaft is of a different length than the original. There should also be two springs on your governor control rod, one in front and one behind the block that connects the rod to the governor. Internally, worn, tired or broken springs can cause it. A bad thrust bearing can have the same effect.
Where you're hunting, one of the easiest things I'd check out first is the governor-to-carb link on the left side. With the motor stopped, find the rod that connects the carb to the governor and remove the pin and clevis at the front end where they attach to the governor arm. Then set your throttle lever (at the seat) fully forward. Go back to the carb and hold that rod and the governor arm both as far to the rear as they will go, without putting tension on the spring resistance you'll feel in the governor arm. Then thread that clevis (if everything is there, there'll be a jam nut up against it) whichever way it has to go so that you can get the pin back through the clevis and governor arm.
That may take care of the hunting-- if not there is another adjustment that may fix it, or you may have an internal problem in the governor.
And even if it takes care of the hunting, it may still not give you back full range on the throttle control.
There's a couple of the guys who have had some success with that by straightening and bending the control rod from the lever to the governor to change its length. I haven't had to do it, but maybe one of them will chime in with ideas in that direction.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
