Posted by The tractor vet on February 03, 2009 at 17:39:28 from (76.212.225.98):
In Reply to: 806 steering, brakes posted by Ronnie Langford on February 03, 2009 at 17:15:26:
There are a couple things here that could be the problem ,(1) the O/Ring between the speed transmisson is old and hard and not sealing well or the last time someone had that tractor split they forgot to replace the O/Ring ,(2) the MCV pump is getting tired and not doing the job anymore . (3) you could have a sicking valve in the MCv or weak springs . So the cheap easy way is to over fill the system and this will take care of any air entering the MCV system and help on fluid pick up. IF this does not solve the problem then it is time to break open the piggy bank an d get a new pump and a seal and gskt pkg. for the MCV and a new spring kit and go thru the MCV . For this ya need to get at least a I T manual and a set of dial calipers and a pressure gauge and fitting to make the correct pressure setting .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.