Posted by Nebraska Kirk on February 01, 2009 at 18:33:14 from (207.91.30.3):
In Reply to: F4 mag ? posted by jiminny on February 01, 2009 at 09:20:33:
Doug Steinbach said: (quoted from post at 11:08:35 02/01/09) can someone tell me if the wire in the photo is supposed to be attached to something. One of course touches on the top of the coil, but where does the other one go?
That second wire does not go anywhere. It is supposed to be where it is for a safety spark gap. If the mag is rotated without it being hooked up to spark plugs, there has to be a way for the high voltage spark to escape to ground without it's creating a path where there should not be one, thus the reason for the safety spark gap.
As for the kill wire that F-Dean mentioned. I would not do that, the F4 mag already has a built-in kill switch. The cap that covers the points rotates to adjust timing, when the cap is turned all the way in one direction (I don't remember which at the moment) it grounds the points and kills the tractor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.