I'm pretty sure you're talking about the bolts at the bottom, inside the box that hold it to the deck. I've looked mine over with an eye to taking it off. If they had god heads on them, you could remove the seat mounting plate on top(another challenge) and get a socket on an extension down to them through the slots from above. If they're rounded or rotted off, are they such that trying to get an undersize or metric socket on them might work? If not, it likely will mean having to work through the hole at the back and will be a real pain in the neck any way you go at it. To get in there with any tool is a challenge. If they're rounded off, it's even more so.
Worse comes to worse, I suppose you could get in there with a cutting wheel on a Dremel (tedious, but small, cutting wheels are fragile)or a die grinder (better, if you can get it in there AND still see what you're doing) and cut the heads off, then proceed with your favorite combination of heat, penetrants, welded nuts, extracting gadgets or drilling to get them out.
That's about all I can come up with off the top of my head. I'll be watchin' with interest here hopin' to learn something.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
